Sustainable Water Resources Management, Journal Year: 2024, Volume and Issue: 10(5)
Published: Sept. 28, 2024
Language: Английский
Sustainable Water Resources Management, Journal Year: 2024, Volume and Issue: 10(5)
Published: Sept. 28, 2024
Language: Английский
Journal of Water Process Engineering, Journal Year: 2024, Volume and Issue: 67, P. 106186 - 106186
Published: Sept. 25, 2024
Language: Английский
Citations
21Environmental Pollution, Journal Year: 2024, Volume and Issue: 358, P. 124534 - 124534
Published: July 14, 2024
Language: Английский
Citations
16Case Studies in Thermal Engineering, Journal Year: 2024, Volume and Issue: 61, P. 105074 - 105074
Published: Sept. 1, 2024
The complete investigation of the solubility Ceftriaxone sodium drug has not yet been conducted. This communication investigates in supercritical CO2 (SC-CO2) for first time. measurements were performed using utilizing UV-vis analysis under different operation conditions (at P (bar) = 120-270 and T (K) 308-338). results demonstrated that ranged from 0.90 × 10-6 to 8.01 10-6. mole fraction increases proportionally with an increase pressure, while maintaining a constant temperature. However, crossover was noted. behavior SC-CO2 modeled by Peng-Robinson equation state (PR EoS) Kwak-Mansoori van der Waals mixing rules seven semi-empirical correlations (Bian et al., Kumar-Johnston, Chrastil, Garlapati-Madras, Bartle Sung-Shim Sodeifian al.,). vaporization, total solvation enthalpies sodium/SC-carbon dioxide system obtained KJ, al. correlations. evaluation two methods absolute average relative deviation (AARD%). Both models exhibited satisfactory level agreement experimental data. Finally, PR/KM EoS Chrastil models, AARD% values 8.70% 8.10% respectively, showed superior precision accurately fitting
Language: Английский
Citations
9Desalination and Water Treatment, Journal Year: 2024, Volume and Issue: 319, P. 100530 - 100530
Published: June 12, 2024
This study investigated the electrocoagulation (EC) treatment of tannery wastewater using plane and punched aluminum iron electrodes at optimum condition pH 9, voltage 20 V, electrode distance 1 cm 90 min electrolysis duration. The efficiency EC process was determined by evaluating levels biochemical oxygen demand (BOD), chemical (COD), Chromium (Cr) in treated effluents. experiment utilized both linear regression Artificial Neural Network (ANN) models for modeling, with ANN model validating predicted from experimental design 95 % confidence. use resulted an removal BOD (89.66 %), COD (96.21 Cr (96.05 TDS (95.77 %). On other hand, achieved a 90.86 98.62 96.94 (Cr), 96.92 (TDS). Similarly, when electrodes, BOD, COD, 87.57 %, 94.77 93.42 93.08 respectively, while removed 89.01 96.59 94.66 TDS. results demonstrate that proposed effectively predicts effluent TDS, addressing economic environmental sustainability concerns.
Language: Английский
Citations
8ChemistrySelect, Journal Year: 2024, Volume and Issue: 9(23)
Published: June 18, 2024
Abstract The present study performed synthesis and characterization nanocomposite based polysaccharide Chitosan/Agar Chitosan/Agar/SiO 2 nanoparticles as adsorbents for remove amoxicillin naproxen the pharmaceuticals from an aqueous solution. structure morphology of were investigated using X‐ray diffraction (XRD), scanning electron microscopy (SEM), energy dispersive spectroscopy (EDX), Fourier‐transform infrared (FTIR), Transmission (TEM), Field Emission Scanning Electron Microscopes (FE‐SEM) Dynamic light scattering (DLS). removal performance adsorbent removing sample pharmaceutical industry effluents in solutions was under different influence factors, including contact time, initial concentration, pH conditions temperature. maximum adsorption with Agar/Chitosan Agar/Chitosan/SiO at concentrations 20 mg/l 97.85 % 87.9 %, respectively. With increasing temperature 10 to 30°C, efficiency both is 99 %. prepared nanocomposites showed good adsorbing amoxicillin. 91 amoxicillin, optimum condition by concentration: mg/l, dose: 0.05 g, time: min, pH=6.
Language: Английский
Citations
5Journal of Water Process Engineering, Journal Year: 2024, Volume and Issue: 68, P. 106470 - 106470
Published: Nov. 11, 2024
Language: Английский
Citations
4Water Resources and Industry, Journal Year: 2025, Volume and Issue: unknown, P. 100294 - 100294
Published: May 1, 2025
Language: Английский
Citations
0Heliyon, Journal Year: 2024, Volume and Issue: 10(16), P. e36489 - e36489
Published: Aug. 1, 2024
The accurate evaluation of the effective mechanical properties composites mainly depends on characteristics representative volume elements (RVEs). This paper investigates RVE size. Additionally, effect fraction reinforcement, edge effect, and types critical size are discussed. First, Al/Ni multilayered were processed by nine cycles cross-accumulative roll bonding (CARB) method. Then, one type RVEs was created based cross-sectional micrographs to consider their inhomogeneities. Another generated using random sequential adsorption (RSA) procedure. Thereafter, homogenized elastic both microstructure-based RSA-based computed compared as a function Ni results showed that increasing fragments, indicated stiffer behavior. By from 0.2 Vf 0.8 Vf, Poisson ratio decreased 7 % modulus increased 83 for RVE. Regarding (0.8 Vf), largest (size 1) with length 575 μm width smallest 5) 287.5 μm, 16 decrease, respectively.
Language: Английский
Citations
2IUBMB Life, Journal Year: 2024, Volume and Issue: unknown
Published: Sept. 16, 2024
Abstract This current investigation explored the thermal conversion process of castor wood into biochar, which was subsequently harnessed for removing naproxen from pharmaceutical industrial effluent via adsorption. Surface composition analyses conducted through scanning electron microscopy–energy dispersive X‐ray, laser‐induced breakdown spectroscopy, and Fourier‐transform infrared studies unveiled presence nano MgO particles within adsorbent material. Employing optimization techniques such as response surface methodology facilitated a refined approach to batch study. The optimized conditions sodium (NPX) adsorption on nano‐MgO‐modified biochar were identified pH 4, 1.5 g/L dosage, 120‐min contact time maintaining constant NPX concentration 10 mg/L. capacity calculated be 123.34 mg/g nano‐magnesium oxide‐modified (modified biochar) 99.874 pristine (pristine biochar). Fenton's reagents comprising 15 mM FeSO 4 (7H 2 O) 25 H O have been scrutinized under 3.0, reaction 30 min, temperature 30°C, stirring at 120 rpm, followed by treatment. COD, NH 3 –N, NO − , PO 3− removal percentages found 90%, 87%, 79%, 80%, respectively. Thus MgO‐modified holds promise treatment effluent.
Language: Английский
Citations
2Sustainable Water Resources Management, Journal Year: 2024, Volume and Issue: 10(5)
Published: Sept. 28, 2024
Language: Английский
Citations
1