Improved MnO2 based electrode performance arising from step by step heat treatment during electrodeposition of MnO2 for determination of paracetamol, 4-aminophenol, and 4-nitrophenol DOI Creative Commons

Afsaneh Seifi,

Abbas Afkhami, Tayyebeh Madrakian

и другие.

Scientific Reports, Год журнала: 2024, Номер 14(1)

Опубликована: Ноя. 4, 2024

The design of electrochemical sensors is crucial considering important factors such as efficiency, low cost, biocompatibility, and availability. Manganese oxides are readily available, low-cost, biocompatible materials, but their conductivity limits efficiency sensors. Today, morphology engineering manganese oxide has been one the most common research topics, because oxides' properties highly dependent on morphologies. In this study, a method for reducing charge transfer resistance (Rct) MnO2-based electrodes was established by cyclic voltammetry technique accompanied step-by-step heat treatment to electrodeposition MnO2 nanofilm, which remarkably improved Rct. Next, sensing performance MnO2/FTO two separate measurements examined, simultaneous measurement paracetamol (PAR) 4-aminophenol (4-APh), other 4-nitrophenol (4-NP). Under optimum conditions, linear ranges 4-APh, PAR, 4-NP, were 0.8 22.0 µM, 2.0 55.0 0.1–250 with detection (LOD) 0.19 0.60 0.01 respectively. It also unaffected 200-fold excess interferences. addition, designed sensor successfully applied analysis real samples.

Язык: Английский

The Emergence of Automation in Electrochemistry DOI Creative Commons
Michael A. Pence,

Gavin Hazen,

Joaquín Rodríguez‐López

и другие.

Current Opinion in Electrochemistry, Год журнала: 2025, Номер unknown, С. 101679 - 101679

Опубликована: Март 1, 2025

Язык: Английский

Процитировано

0
Improved MnO2 based electrode performance arising from step by step heat treatment during electrodeposition of MnO2 for determination of paracetamol, 4-aminophenol, and 4-nitrophenol DOI Creative Commons

Afsaneh Seifi,

Abbas Afkhami, Tayyebeh Madrakian

и другие.

Scientific Reports, Год журнала: 2024, Номер 14(1)

Опубликована: Ноя. 4, 2024

The design of electrochemical sensors is crucial considering important factors such as efficiency, low cost, biocompatibility, and availability. Manganese oxides are readily available, low-cost, biocompatible materials, but their conductivity limits efficiency sensors. Today, morphology engineering manganese oxide has been one the most common research topics, because oxides' properties highly dependent on morphologies. In this study, a method for reducing charge transfer resistance (Rct) MnO2-based electrodes was established by cyclic voltammetry technique accompanied step-by-step heat treatment to electrodeposition MnO2 nanofilm, which remarkably improved Rct. Next, sensing performance MnO2/FTO two separate measurements examined, simultaneous measurement paracetamol (PAR) 4-aminophenol (4-APh), other 4-nitrophenol (4-NP). Under optimum conditions, linear ranges 4-APh, PAR, 4-NP, were 0.8 22.0 µM, 2.0 55.0 0.1–250 with detection (LOD) 0.19 0.60 0.01 respectively. It also unaffected 200-fold excess interferences. addition, designed sensor successfully applied analysis real samples.

Язык: Английский

Процитировано

1