
Journal of Advanced Ceramics, Год журнала: 2024, Номер 14(1), С. 9221007 - 9221007
Опубликована: Ноя. 25, 2024
Язык: Английский
Journal of Advanced Ceramics, Год журнала: 2024, Номер 14(1), С. 9221007 - 9221007
Опубликована: Ноя. 25, 2024
Язык: Английский
Small, Год журнала: 2025, Номер 21(7)
Опубликована: Янв. 6, 2025
Abstract Owing to its abundant manganese source, high operating voltage, and good ionic diffusivity attributed 3D Li‐ion diffusion channels. Spinel LiMn 2 O 4 is considered a promising low‐cost positive electrode material in the context of reducing scarce elements such as cobalt nickel from advanced lithium‐ion batteries. However, rapid capacity degradation inadequate rate capabilities induced by Jahn–Teller distortion dissolution have limited large‐scale adoption spinel for decades. In this study, 1.98 Mg 0.005 Ti Sb Ce (HE‐LMO) with remarkable interfacial structural cycling stability developed based on complex concentrated doping strategy. The initial discharge retention HE‐LMO are 111.51 mAh g −1 90.55% after 500 cycles at 1 C. as‐prepared displays favorable stability, significantly surpassing pristine sample. Furthermore, theoretical calculations strongly support above finding. has higher more continuous density states Fermi energy level robust bonded electrons among Mn─O atom pairs. This research contributes field high‐entropy modification establishes facile strategy designing manganese‐based batteries (LIBs).
Язык: Английский
Процитировано
2ACS Nano, Год журнала: 2024, Номер unknown
Опубликована: Ноя. 28, 2024
Single-crystalline Ni-rich layered oxides are one of the most promising cathode materials for lithium-ion batteries due to their superior structural stability. However, sluggish diffusion kinetics and interfacial issues hinder practical applications. These intensify with increasing Ni content in ultrahigh-Ni regime (≥90%), significantly threatening viability single-crystalline strategy oxide cathodes. Herein, by developing a high-entropy coating strategy, we successfully constructed an epitaxial lattice-coherent rock-salt layer (∼3 nm) via Zr Al doping on surface LiNi
Язык: Английский
Процитировано
8Chemical Engineering Journal, Год журнала: 2025, Номер unknown, С. 160309 - 160309
Опубликована: Фев. 1, 2025
Язык: Английский
Процитировано
1Ceramics International, Год журнала: 2025, Номер unknown
Опубликована: Янв. 1, 2025
Язык: Английский
Процитировано
0Advanced Energy Materials, Год журнала: 2025, Номер unknown
Опубликована: Апрель 2, 2025
Abstract Rechargeable zinc‐ion batteries (ZIBs) have gained significant attention as potential next‐generation energy storage systems, owing to their inherent safety, environmental benignity, and cost‐effectiveness. However, the substantial electrostatic repulsion of Zn ion results in a sluggish kinetics for its insertion into cathode material. Meanwhile, formation hydrated ionic groups with increased mass volume aqueous electrolyte further hampers transport ability zinc ions, significantly impacting overall electrochemical performance (including capacity, density, rate‐capability, cyclability) batteries. This review systematically summarized recent progress regulation strategy kinetics. The as‐reported mechanisms are introduced ZIBs (Zn 2+ insertion/extraction mechanism, H + or 2 O/ co‐insertion/extraction conversion reaction coordination mechanism). Then, material design fast including soft lattice construction, doping effects, defect introduction, morphology control, interface is summarized. Finally, it concluded future research directions, such high‐entropy design, multi‐scale simulation, machine study, providing roadmap developing high‐performance at ultralow operation temperatures.
Язык: Английский
Процитировано
0Energy storage materials, Год журнала: 2025, Номер unknown, С. 104228 - 104228
Опубликована: Апрель 1, 2025
Язык: Английский
Процитировано
0ACS Applied Materials & Interfaces, Год журнала: 2025, Номер unknown
Опубликована: Апрель 6, 2025
Layered oxides are considered promising cathode materials for sodium-ion batteries (SIBs) due to their high energy density, flexible compositions, and low cost. However, they encounter significant challenges, such as multiphase transitions structural instability at voltages, which limit large-scale practical application. In this study, we employed a dual modification strategy involving complex composition doping phosphate coating fabricate the Na0.67Ni0.255Mn0.645(TiMgCuZn)0.1O2@phosphate (D-NNM). The lattice distortion induced by optimizes overall properties of cathode, while forms robust electrode interface through stable P-O bonds. This comprehensive stabilizes phase interfacial structure, thereby enhancing Na+ transport mitigating mechanical degradation surface reactions voltages. Consequently, D-NNM exhibited an initial capacity 136.9 mA·h·g-1 with average potential 3.45 V maintained 85% after 60 cycles 4.4 V, twice that pristine cathode. demonstrated faster diffusion kinetics voltage without any particle cracks observed even 50 cycles. offers protection layered from bulk provides insights into design density cathodes SIBs.
Язык: Английский
Процитировано
0Journal of Materiomics, Год журнала: 2025, Номер unknown, С. 101060 - 101060
Опубликована: Апрель 1, 2025
Язык: Английский
Процитировано
0ACS Sustainable Chemistry & Engineering, Год журнала: 2025, Номер unknown
Опубликована: Апрель 18, 2025
Язык: Английский
Процитировано
0Journal of Molecular Structure, Год журнала: 2025, Номер unknown, С. 142496 - 142496
Опубликована: Апрель 1, 2025
Язык: Английский
Процитировано
0