
Case Studies in Thermal Engineering, Год журнала: 2024, Номер 64, С. 105431 - 105431
Опубликована: Ноя. 7, 2024
Язык: Английский
Case Studies in Thermal Engineering, Год журнала: 2024, Номер 64, С. 105431 - 105431
Опубликована: Ноя. 7, 2024
Язык: Английский
Journal of the Energy Institute, Год журнала: 2024, Номер 113, С. 101540 - 101540
Опубликована: Янв. 21, 2024
Язык: Английский
Процитировано
23Results in Engineering, Год журнала: 2024, Номер 22, С. 102066 - 102066
Опубликована: Март 31, 2024
The accumulation of plastic waste poses a major environmental challenge, while the conversion plastics into oil via pyrolysis holds promise as an alternative energy solution. Despite numerous investigations this area, none have focused on optimizing process parameters for higher yield and enhancing overall performance through suitable fuel modification. present study aims to optimize parameters, including heating rate (HR), temperature (PT), reaction time (RT), achieve (WPO) enhance by blending optimal quantities water. Fuel characterization properties measurement were conducted using Fourier Transform Infrared ASTM methods. WPO was blended with conventional diesel (CDF) different volume concentrations water (5%, 10%, 15%). metrices assessed under various engine conditions. findings indicate that optimum condition is HR 17.3 °C/min, PT 403 °C, RT 96.30 min, quality confirms its suitability source. metrics revealed has 5.4% lower brake-thermal efficiency than CDF, inclusion 10% in (WPO10W) enhances 11.5%. in-cylinder pressure net-heat release are 1.3% 12.9% respectively, WPO10W emulsion promotes efficient combustion. reduces oxides nitrogen, hydrocarbon, carbon monoxide emissions 21.2%, 9.8%, 22.2%, compared WPO.
Язык: Английский
Процитировано
17Process Safety and Environmental Protection, Год журнала: 2025, Номер unknown, С. 106787 - 106787
Опубликована: Янв. 1, 2025
Язык: Английский
Процитировано
1Materials for Renewable and Sustainable Energy, Год журнала: 2025, Номер 14(1)
Опубликована: Янв. 15, 2025
Abstract The increasing demand for cost-effective materials energy storage devices has prompted investigations into diverse waste derived electrode supercapacitors (SCs) application. This review examines advancements in converting carbon-based SCs renewable storage. In this context, different precursor sources have been explored over the years as electrodes SCs. These comprise of industrial, plastics and biowastes, including plant animal wastes. capabilities various are highlighted to provide an understanding unique features that make them applicable addition, some challenges associated with waste-derived terms emphasized. Here, we also provided insights recent progress synthesis techniques their effects on electrochemical performance. performance tailoring material structures through incorporation form composites optimized methods is effective strategy. Hence, outlined include pyrolysis, hydrothermal, microwave-assisted, template-assisted, sol–gel techniques. effect discussed. Overall, highlights valorization future research directions scaling challenges.
Язык: Английский
Процитировано
1Results in Engineering, Год журнала: 2024, Номер 22, С. 102345 - 102345
Опубликована: Июнь 1, 2024
Despite emulsification of water in-diesel can decrease harmful exhaust emissions, unstable emulsion result in formation free which accelerate metal corrosion the fuel delivery system a diesel engine. This study aimed to formulate and assess stability 5 vol% biodiesel (W5B5) investigate its effects towards copper corrosion. Stable W5B5 was successfully prepared with 3 polyglycerol polyricinoleate (PGPR). After 1200 h storage, remained stable, indicated by mean droplet diameter 627.6±7.5 nm, sedimentation index ∼3%, absence formation. Upon exposure copper, increased 2.7 times compared W5B5. Viscosity total acid number (TAN) values exposed 26% 270%, respectively, indicating enlargement droplets degradation during immersion. Corrosion rate decreased 92% between 240 5.5 3.0 higher biodiesel, respectively. Higher initial TAN than other fuels, attributed addition PGPR form stable water-fuel emulsion, influenced observed fuels. To minimize corrosive nature W5B5, future research should focus on developing formulation low acidity value comparable or even lower biodiesel. The contribution knowledge from yielded valuable insights into fuel, behaviour, impact emulsifier rates.
Язык: Английский
Процитировано
8Journal of Marine Science and Application, Год журнала: 2023, Номер 22(4), С. 870 - 881
Опубликована: Дек. 1, 2023
Язык: Английский
Процитировано
15Recycling, Год журнала: 2025, Номер 10(1), С. 2 - 2
Опубликована: Янв. 1, 2025
This paper reports the results of a study on significance inertization system configuration laboratory-scale fixed bed batch reactor with regard to yield pyrolysis oil and conversion. Two typical systems were investigated depending whether carrier gas (nitrogen in this study) was added from top or bottom reactor. Polypropylene (PP) packaging waste (100 g) used as model sample. A factorial experimental design adopted for one categorical parameter, arrangement parts system. All experiments conducted at 475 °C, flow rate 0.1 L/min reaction time 90 min. Statistical analysis processing showed that had remarkable impact yield, while its overall conversion negligible. When applying two observed methods inertization, average yields differed by 1.7% 1.8%, respectively. applied statistical treatments level 0.05, i.e., there only 5% chance incorrectly rejecting hypothesis equality arithmetic means when different applied. The explanation behavior is attributed temperature change inside reactor, which shows particular suffers local overheating middle part. Local part more pronounced case inerting bottom, leads greater excessive cracking volatile products compared mode thus formation non-condensable gases, reduction pyrolytic oil.
Язык: Английский
Процитировано
0Elsevier eBooks, Год журнала: 2025, Номер unknown, С. 147 - 156
Опубликована: Янв. 1, 2025
Язык: Английский
Процитировано
0Journal of Cleaner Production, Год журнала: 2025, Номер unknown, С. 145631 - 145631
Опубликована: Май 1, 2025
Язык: Английский
Процитировано
0Process Safety and Environmental Protection, Год журнала: 2024, Номер 191, С. 1089 - 1110
Опубликована: Сен. 6, 2024
Язык: Английский
Процитировано
2