Advancing non-destructive weld assessment using autoencoder-based feature extraction DOI
Taha Etem

Nondestructive Testing And Evaluation, Journal Year: 2025, Volume and Issue: unknown, P. 1 - 21

Published: May 3, 2025

Language: Английский

Cross-supervised contrastive learning domain adaptation network for steel defect segmentation DOI

Lixiang Zhao,

Yulong Zhang, Jie Duan

et al.

Advanced Engineering Informatics, Journal Year: 2024, Volume and Issue: 64, P. 102964 - 102964

Published: Dec. 4, 2024

Language: Английский

Citations

4
Investigation of interface characteristics and mechanical performances of Cu/Al plate fabricated by underwater explosive welding method DOI Creative Commons
Jinhua Chen,

Dapeng Zhou,

Xiaohong Zhou

et al.

PLoS ONE, Journal Year: 2025, Volume and Issue: 20(4), P. e0320970 - e0320970

Published: April 3, 2025

Cu/Al composite plate was manufactured by underwater explosive welding method. The interface characteristics and mechanical properties of were evaluated analyzed through phased array ultrasonic inspection, microstructure, uniaxial tensile test, three-point bending shearing test microhardness test. results showed that the thin Cu Al plates is achieved welding, with a thickness only 0.5 mm. A well bonded between obtained, at detonation velocity 4 000 m/s, when distance foil 0.2 There are wavy fusion zones bonding plate. No delamination or cracks found during tests, local cracking occurs necking part in due to severe deformation. strength minimum reaches 133 72.9 MPa, respectively. hardness values zone, reach 385, 135 52 HV, increase near mainly caused severed deformation induced intense shock pressure.

Language: Английский

Citations

0
Advancing non-destructive weld assessment using autoencoder-based feature extraction DOI
Taha Etem

Nondestructive Testing And Evaluation, Journal Year: 2025, Volume and Issue: unknown, P. 1 - 21

Published: May 3, 2025

Language: Английский

Citations

0