Cited by Efficiency limits of concentrated solar thermophotonic converters under realistic conditions: The impact of nonradiative recombination and temperature dependence

Isothermal pyrolysis and gasification characteristics and gas products of ethylene vinyl acetate and back sheets in end-of-life photovoltaic module thermal treatment recovery DOI

Haoyu Zhang, Renjie Zou, Guangqian Luo

et al.

Fuel, Journal Year: 2025, Volume and Issue: 386, P. 134233 - 134233

Published: Jan. 7, 2025

Language: Английский

Citations

Experimentally validated thermal modeling for temperature prediction of photovoltaic modules under variable environmental conditions DOI

Abdelhak Keddouda, Razika Ihaddadène, Ali Boukhari

et al.

Renewable Energy, Journal Year: 2024, Volume and Issue: 231, P. 120922 - 120922

Published: July 4, 2024

Language: Английский

Citations

Temperature behaviors of transparent solar PV panels under various operating modes: an experimental and numerical study DOI

Qichang Dong,

Xuejiao Wu, Ye Song

et al.

Renewable Energy, Journal Year: 2025, Volume and Issue: unknown, P. 123279 - 123279

Published: May 1, 2025

Language: Английский

Citations

Experimental research on the temperature distribution characteristics of photovoltaic array DOI

Yubing Wen, Xingcai Li,

Weiwei Hu

et al.

Applied Thermal Engineering, Journal Year: 2025, Volume and Issue: 265, P. 125507 - 125507

Published: Jan. 9, 2025

Language: Английский

Citations

Optimization Study of Air-Based Cooling Photovoltaic Roofs: Experimental and Numerical Analysis DOI

Yi He, Yibing Xue,

Yingge Zhang

et al.

Energies, Journal Year: 2025, Volume and Issue: 18(5), P. 1168 - 1168

Published: Feb. 27, 2025

The rapid growth of photovoltaic (PV) installed capacity has driven advancements in technology, such as integrating PV panels into building envelopes. Temperature increases are known to negatively impact panel performance. This study investigates and optimizes the design air-based cooling systems for roofs using experimental numerical analyses, leveraging free natural convection cooling. Experimental measurements included air inlet/outlet, panel, roof surface temperatures. primary parameters examined Computational Fluid Dynamics (CFD) were heights widths channels between rooftop, with ranging from 25 mm 75 varying 200 400 mm. There good agreements results after model validation. reveal significant temperature non-uniformity across panels, a maximum difference 16.50 °C. shading effect resulted an average reduction by 12.90 Parametric studies showed that changes height had more pronounced on than width. optimal was identified channel size × mm, resulting lowest 65.21 °C enhanced uniformity, efficiency reaching 11.54%.

Language: Английский

Citations

Thermal comparison of floating bifacial and monofacial photovoltaic modules considering two laying configurations DOI

Giuseppe Marco Tina, Amr Osama, Gaetano Mannino

et al.

Applied Energy, Journal Year: 2025, Volume and Issue: 389, P. 125732 - 125732

Published: March 26, 2025

Language: Английский

Citations

Effect of electrical operating conditions on thermal behavior of PV modules: Numerical and experimental analysis DOI

Amr Osama, Giuseppe Marco Tina, Antonio Gagliano

et al.

Solar Energy Materials and Solar Cells, Journal Year: 2025, Volume and Issue: 287, P. 113625 - 113625

Published: April 8, 2025

Language: Английский

Citations

Heat dissipation effect of the floating photovoltaic for an inland water test site in China DOI

Runze Wu,

Chao Ma, Zijian Xu

et al.

Energy Conversion and Management, Journal Year: 2024, Volume and Issue: 322, P. 119177 - 119177

Published: Oct. 30, 2024

Language: Английский

Citations

Efficiency limits of concentrated solar thermophotonic converters under realistic conditions: The impact of nonradiative recombination and temperature dependence DOI

Fei Gao,

Xiuwen XiaHou,

Xin Zhang

et al.

Energy Conversion and Management, Journal Year: 2024, Volume and Issue: 321, P. 119102 - 119102

Published: Oct. 1, 2024

Language: Английский

Citations