Low Friction and High Wear Resistant Magnesium Hydroxide Layer Formed on Am50 Magnesium Alloy

Published: Jan. 1, 2025

In order to improve the wear and corrosion resistance of magnesium alloy, hydroxide (Mg(OH)2) layer with a thickness about 20 mm was directly prepared on AM50 alloy substrate in superheated water vapor at 200 oC for 2 h under pressure ~ 0.12 MPa. The preparation layers does not require expensive equipment, complicated manipulation any pretreatment. electrical energy very small amount tap were consumed processing. Compared untreated sample, friction coefficient decreased from ~0.45 ~0.15. rate reduced by approximately times. relatively thick Mg(OH)2 acted enhance alloy.

Language: Английский

---

Microstructure and properties of ceramic coating on H13 steel via plasma electrolytic oxidation in electrolyte based on sodium aluminate

Ceramics International, Journal Year: 2025, Volume and Issue: unknown

Published: Jan. 1, 2025

Language: Английский

---

Effect of MoS2 on the microstructure evolution of laser cladding M2 coatings

Ceramics International, Journal Year: 2024, Volume and Issue: unknown

Published: Dec. 1, 2024

Language: Английский

---

Constructing a superhydrophobic coating of dual-metal (Mo, Ni) MOF on magnesium alloy surface with excellent corrosion resistance and tribological performance

Progress in Organic Coatings, Journal Year: 2024, Volume and Issue: 200, P. 109010 - 109010

Published: Dec. 16, 2024

Language: Английский

---