Utilizing Novel Lignocellulosic Material from Hart’s-Tongue Fern (Asplenium scolopendrium) Leaves for Crystal Violet Adsorption: Characterization, Application, and Optimization DOI Open Access
Giannin Moșoarcă, Cosmin Vancea, Simona Popa

et al.

Polymers, Journal Year: 2023, Volume and Issue: 15(19), P. 3923 - 3923

Published: Sept. 28, 2023

In this work, a new lignocellulosic adsorbent was obtained and tested for crystal violet dye removal from water. The material hart’s-tongue fern (Asplenium scolopendrium) leaves after minimal processing, without chemical or thermal treatment. surface of the characterized using variety techniques, including FTIR, SEM, color analysis. effect various factors on adsorption capacity then investigated discussed. kinetic equilibrium studies showed that general-order model Sips isotherm are most suitable to describe process. time reached 20 min maximum calculated value 224.2 (mg g−1). determined values thermodynamic parameters indicated physical as main mechanism involved in Taguchi method used optimize conditions identify influential controllable factor, which pH. ANOVA (general linear model) calculate percentage contribution each factor efficiency. Analysis all results shows very inexpensive, readily available, effective removing aqueous solutions.

Language: Английский

Clay-based nanomaterials and their adsorptive removal efficiency for dyes and antibiotics: A review DOI
Zeynep Ciğeroğlu, Noureddine El Messaoudi, Zeynep Mine Şenol

et al.

Materials Today Sustainability, Journal Year: 2024, Volume and Issue: 26, P. 100735 - 100735

Published: March 9, 2024

Language: Английский

Citations

91
Efficiency of montmorillonite-based materials as adsorbents in dye removal for wastewater treatment DOI

Angita Sarkar,

Nituraj Mushahary,

Fungbili Basumatary

et al.

Journal of environmental chemical engineering, Journal Year: 2024, Volume and Issue: 12(3), P. 112519 - 112519

Published: March 18, 2024

Language: Английский

Citations

25
CTAB modified metakaolin-based geopolymer microspheres for the selective adsorption and recovery of TcO4−/ReO4− DOI
Qian Li, Min Yi, Lin Shao

et al.

Separation and Purification Technology, Journal Year: 2024, Volume and Issue: 350, P. 127853 - 127853

Published: May 7, 2024

Language: Английский

Citations

12
A novel approach for modification of montmorillonite using banana peel ash extract for enhanced adsorption efficiency of methylene blue dye DOI Creative Commons

Angita Sarkar,

Nituraj Mushahary,

Bipul Das

et al.

Desalination and Water Treatment, Journal Year: 2024, Volume and Issue: 320, P. 100585 - 100585

Published: July 9, 2024

Water contamination from dyes is a major issue that needs to be solved effectively. Addressing this issue, the study aims improve adsorption capacity of montmorillonite (MMT) by its modification for removing methylene blue (MB) dye. Powder XRD, FTIR, FESEM, HRTEM, BET, and XPS were employed analyze modified materials. Various parameters studied optimize efficiency MMT. To enhance removal MMT (70.05 ± 0.16 %), has with banana peel ash extract (BPAE) which achieved maximum MB 98.54 0.31 % under neutral pH, an equilibrium time 150 min, initial dye concentration 120 mg/L, adsorbent dosage 1.4 g/L at ambient temperature (32 °C). Among isotherm models, Langmuir model showed 100 mg/g. Experimental data fitted well Elovich kinetic model. Reusability was efficient up third cycle, retaining 56.96 0.39 efficiency.

Language: Английский

Citations

10
Innovative surface modification of Kaolinite by direct grafting of an anionic surfactant to improve pollutant adsorption and effluent decontamination DOI

Nadia Hamri,

Ali Imessaoudene, Nasma Bouchelkia

et al.

Journal of Dispersion Science and Technology, Journal Year: 2025, Volume and Issue: unknown, P. 1 - 20

Published: Jan. 11, 2025

This study deals with the synthesis of a new Organo-Kaolinite material containing sulfonate groups by grafting an anionic surfactant, sodium dodecylbenzene (SDBS), onto surface Algerian Kaolinite DD3 for use in removal textile dye (Methylene Blue, MB). The investigation kinetics adsorption process is accordance pseudo-second-order model, and isotherm data are Langmuir model two materials, SDBS-DD3. A comparative analysis between SDBS-DD3 showed that despite decrease BET area after modification (from 68 m2/g to 46 m2/g), amount absorbed was 93.8 ± 0.9 mg/g compared 44.5 0.2 DD3. Adsorption experiments on real wastewater effluents significant reduction effluent pollutants. In fact, during first 2 min experiment, chemical oxygen demand (COD) reduced 94%. More specifically, COD value untreated effluent, which initially 304 mg/L, 29 mg/L.

Language: Английский

Citations

1
Use of a novel low-cost adsorbent PANI@Clay composite to effectively remove OG dye from wastewater: Insights from isotherm kinetic and thermodynamic modeling, investigation using density functional theory DFT/MC/MD DOI

Asmaa Khattari,

Jaouad Bensalah, Amar Habsaoui

et al.

Materials Science and Engineering B, Journal Year: 2024, Volume and Issue: 302, P. 117201 - 117201

Published: Jan. 25, 2024

Language: Английский

Citations

8
Standardized methodology for performance evaluation in using polyaniline-based adsorbents to remove aqueous contaminants DOI Creative Commons
Akbar Samadi, Lingxue Kong, Wenshan Guo

et al.

Journal of environmental chemical engineering, Journal Year: 2024, Volume and Issue: 12(3), P. 112650 - 112650

Published: March 30, 2024

In literature, mistakes and inconsistencies in evaluation of the adsorption equilibrium, kinetics, thermodynamics pollutants removal often exist. Here, we review these propose a standardized methodology, with focus on polyaniline (PANI)-based adsorbents to correctly determine equilibrium data, kinetic rates, time, capacity. Removal aqueous by PANI-based through well-designed experiments predominantly involves monolayer chemisorption. The nature adsorption, whether heterogeneous or homogeneous, is contingent upon morphological characteristics distribution functional groups adsorbents. literature reflects multitude complexities implementation subsequent analysis results. Researchers have attempted address complexities, yet variations findings remain due diverse experimental conditions applied. This study critically examines existing methodologies their develop distinctive approach for rational design, meticulous sampling, accurate calculations. Controversial descriptions regarding kinetics are scrutinized scientifically reasonable presented. Finally, main steps determining mechanisms via physiochemical studies recommended. contributes insightful perspectives field offering more robust methodology conduct interpret results, thereby enhancing reliability comparability adsorption.

Language: Английский

Citations

8
Highly efficient batch adsorption of anionic dye in wastewater using nanocomposite: Experimental and theoretical studies DOI Creative Commons

Fatiha Bessaha,

Gania Bessaha,

Assia Benhouria

et al.

Desalination and Water Treatment, Journal Year: 2024, Volume and Issue: 317, P. 100292 - 100292

Published: Jan. 1, 2024

The adsorptive properties of the Erionyl Red (ER) dye on bentonite (B) intercalated with cetyltrimethylammonium bromide (HDTMA-B) were investigated using experimental and statistical physics methods. was then taken up by from a real water sample. After intercalation, X-ray diffraction analysis indicates an increase in HDTMA-B basal spacing to 15.2 Ả. Scanning electron microscopy images show formation large particles many cavities. results revealed that material had high adsorb organic molecules (greater than 99%). Langmuir-Freundlich model, described isotherms, whereas second-order model better captured kinetic adsorption. maximum ER uptake observed 478 mg g-1 at temperature 328 K. Reusability nanocomposite showed stability, over five cycles. Thermodynamic suggested spontaneous (negative ΔG°) endothermic (positive ΔH°) adsorption processes. also used estimate orientation material. oxygens connected structure played particular important role mechanisms dye. This study combines experiment data theoretical approach provide new explanation for mechanism. removal dyes wastewater, red, is vital protection environment public health. Nanocomposite appears be effective, durable, environmentally friendly adsorbent red synthetic solutions wastewater.

Language: Английский

Citations

7
Mesoporous Fe3O4@SiO2@La Nanocomposite for Efficient Methylene Blue Removal from Wastewater DOI

Shirin Yazdizadeh,

S. Yousef Ebrahimipour, S. Jamilaldin Fatemi

et al.

Journal of Molecular Structure, Journal Year: 2024, Volume and Issue: 1322, P. 140337 - 140337

Published: Oct. 10, 2024

Language: Английский

Citations

7
Bimetallic Organic Gel for Effective Methyl Orange Dye Adsorption DOI Creative Commons
Hua Jin, Xinyuan Xu, Xiao‐Yang Yu

et al.

Gels, Journal Year: 2024, Volume and Issue: 10(3), P. 208 - 208

Published: March 19, 2024

A bimetallic organic gel (MOG-Fe/Al) was synthesized through the solvothermal method. The state of product obtained under optimized formation conditions is sufficient to carry 2 g weight for a long time. Scanning electron microscopy (SEM), X-ray diffraction (XRD), Fourier transform infrared (FT-IR) spectroscopy, Brunauer–Emmett–Teller (BET) technique, and photoelectron spectroscopy (XPS) analysis confirmed structures morphologies materials. MOG-Fe/Al, with good stability, excellent durability, wide applicability, exhibited efficient MO adsorption capacity as high 335.88 mg/g at 25 °C. Adsorption-influencing factors including solution pH, contact time, temperature were investigated. performance better than that monometallic gels (MOG-Fe MOG-Al), its processes in accordance pseudo-second-order kinetic Langmuir isothermal models. MOG-Fe/Al due surface structure, pore volume, π-π interactions, hydrogen bonds, electrostatic interactions.

Language: Английский

Citations

6